10/13/2026 [20:59:00] GMT Home .:. Logout
Forums
Hardmaps.com :: Forums :: Map Making Forum :: Task Force Dagger
 
<< Previous thread | Next thread >>
Absolute Height
Moderators: Hardmaps Administrator, *HmS*Wedge, *HmS*grunt, *HmS*Trevor, *HmS*LongBow
Author Post
*HmS*Wedge
Wed Aug 25 2004
Captain Slow

Registered Member #3
Joined: Fri Dec 19 2003
Location: Scotland
Posts: 4651
Absolute Height


Tunnels and Fences/Walls on uneven ground:
IF you're placing any objects on flat and uneven ground:
First, place one object on the flat ground and keep it highlighted. Go into the item attributes for it and click on ABSOLUTE HEIGHT. Take note of the number - Write it down!

Now then, place your other objects as you wish and if they fall on higher ground, don't worry about it till you are done. Once you complete, highlight all of the objects you wish to adjust, and then in the item attributes box,
click ABSOLUTE HEIGHT, then place that number you wrote down, then unselect all. What happened is that all of the pieces you had highlighted are now set to the same level. When you enter the map, you will see that some of your objects have sunken into the raised areas and will be still even with the other items through out.

This works for tunnel sections also, the only difference is that you have to subtract 5 or 8 from that number
in order to equal your stairs or ramp doing down from the entrance. If you are unsure of the height of the stairs, there's 2 types: one with only 2 landings - this one goes down 5 meters, and one with 3 landings, this one goes down 8 meters. Also, the 2 landing stairs, when you get to the bottom, your direction will be 180 degrees from the direction you started with at the top, where as with the 3 landing stairs, you'll be going the same direction at the bottom as the top. Also, look closely as you place some tunnel parts in the map, they may have a - 8 right there in the piece, this tells you that this item must be placed at - 8 meters below the ground.


[ Edited ]
Back to top
Website
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System
All trademarks are copyright their respective owners.
This site is best viewed using 1280-1024 screen resolution.
{THEMEDISCLAIMER}
Render time: 0.0655 sec, 0.0210 of that for queries.